SUNKEN CONCRETE PROBLEMS? Trip Hazards Garage Floors Patios Steps Walkways Driveways Sidewalks Raise Your Sunken Concrete with Polyurethane Injection
3/8" holes are drilled through the sunken slabs.
High density polyurethane is pumped under the slab raising it to the desired height.
The holes are patched with cement.
This process is a cost-effective alternative to replacing sunken concrete. PolyTech Enterprise is the ONLY contractor in East Texas to offer lightweight polyurethane injection.
PolyTech Enterprise Dallas and East Texas
To learn more about High Density Polyurethane Injection and its different applications for concrete raising, stabilization and void filling, please contact one of our polyurethane experts. The options are endless when you have the right product for the right job. Find out if High Density Polyurethane is right for your next job.
Benefits for Dallas and East Texas Areas
Avoids costly tear out and replacement—allows the project to run smoothly and avoids down time.
Quick Cure Time
Typically cures 15 minutes after injection allowing areas to be fully available in minutes not days.
Can be used under water or in wet applications and have the same results.
The foam-like material is resistant to water penetration.
Weighing only 100–150 pounds per yard, high density polyurethane is comparably 3,000 pounds LESS per yard than traditional mudjacking material.
3/8” Injection Holes
Injection ports leave small injection holes and allow for less visible patching.
Can spread into voids as small as 1/32”. Polyurethane foam will expand and flow into cracks and voids expanding far beyond the initial injection hole.